TONI&GUY takes the blunt, rocker fringe in a dazzling, ethereal new direction. As part of the Freedom Collection, this look, entitled "Frankie" shows the softer side of "rocker chic".
STEPS
Take a diagonal back parting 2" in from the front hairline to the top of each ear.
Take a horizontal parting at the top of the occipital and isolate the hair underneath it.
Separate the fringe with a triangular section at the recession area, comb to 90° and point cut square.
Cross check at natural fall, creating a rounded line.
With the remaining hair in the section, use the cheekbone to measure a
guide to length, elevate to 90° and cut square.
Continue with a pivoting diagonal back section, comb to 90° and cut square following the guide. Work pivoting diagonal back sections and repeat the technique until reaching to the profile parting. Repeat this technique on the opposite side.
To blend the underneath, take a center vertical section, comb to 90° and slide cut out to blend with the existing perimeter. Continue with a pivoting section, comb to 90°, over direct to the previous section and slide cut to blend. Repeat this technique until all the remaining lengths have been blended.
Blow dry with a flat brush, then detail with a large round brush.
To detail the perimeter, comb to natural fall and slice into the length to emphasize a soft textured line
The fringe is personalized with point cutting.
The sides are detailed with channel cutting. The interior is reworked with deep parallel point cutting to create more texture.
