STEPS
Create a center part from crown to nape and sub-divide from ear to ear. Cut a blunt perimeter line.
Drop successive subsections and use guide to complete perimeter shape.
Release front left panel and connect to the back with model's head turned. Angle cut slightly downward to ensure longer length. Repeat on front right panel.
Finished perimeter shape. Blow dry using a flat wrap method.
Establish a fringe appropriate for guest. Here, the line sits at the model's eye level.
Completed fringe.
Begin to create short, disconnected layers through the top of the head. Start guideline just below the fringe.
Elevate section and point-cut.
Increase elevation with each subsection.
Continue layering into the back panel of the hair cut.
Continue this technique through the back panel of hair. Take diagonal sections that follow the natural curvature of the head. Repeat on the other side.
Connect both sides through the top by point-cutting the point that is created.
Slice and point-cut to personalize the shape.
Completed cut. Ready for color.
Natural Starting Level: 6
Color Formulas:
Teak
Full Spectrum™ Protective Permanent Creme Hair Color 40g 6N Dark Blonde + 2g Dark Yellow/Orange Pure Tone + 2g Dark Red/Violet Pure Tone + 40ml 20-Volume Color Catalyst™ Creme DeveloperRosewood
Full Spectrum™ Protective Permanent Creme Hair Color 40g 7N Medium Blonde + 2g Dark Red/Violet Pure Tone + 40ml 30-Volume Color Catalyst™ Creme DeveloperBeechwood
Shades of Enlightenment™ Advanced Lifting Creme Hair Color 20g Dusk Extra Light Ash Blonde + 20g Sunrise Extra Light Beige Blonde + 40ml 40-Volume Color Catalyst™ Creme Developer
Take a horseshoe section separating the layered top of the hair cut and clip hair away. (Photo shows section divided for control.)
Take another inverted horseshoe section from behind each ear and include the point of distribution.
Apply barrier cream to protect client's skin from color.
Apply Teak to entire back panel.
After apply Teak to the entire back panel, isolate entire section with foil.
Completed back panel.
Create a crescent section mirroring the side of the horseshoe section from the point of distribution to the top of the ear. Repeat on the other side.
Apply Rosewood to these panels.
Create a parting that parallels the front hairline from the top of the ear to the top section. Create an offset triangular-shaped section. Repeat on the oposite side of of the head.
Apply Beachwood to these panels. Isolate with foil.
Apply Teak to the remaining front hairline panels. Isolate with foiil.
Re-section the top panel, taking out a U-shaped fringe of hair.
Apply Teak to the entire panel.
Apply Rosewood to the remaining U-shaped subsection. Isolate with foil. Process according to directions. Shampoo and condition with Color Conserve products.
